thermal-lensing compensation

Design of Cold End Self-motion Compensation of K Thermal Couple on the Basis of Single Chip

基于单片机的K型热电偶冷端自动补偿设计（热电偶的）端的类型

A phased array antenna requires calibration and compensation of amplitude/ phase errors due to element mutual coupling, component manufacturing and assembly tolerances, ageing, thermal distortion and component replacement.

相控阵天线由于单元间互耦、器件的制造、组装误差、老化、热变形和组件更换的影响而产生幅相误差，必须进行校准和补偿。

This monitoring device uses electric thermal couple as the head temperature sensor by finally actuating the LED displaying the measured results through cold-juncture compensation circuit, RC filter circuit, amplifier circuit and A/ D convert.

发动机缸盖温度监测仪采用热电偶作为缸盖温度传感器，通过冷端补偿电路，RC滤波电路、放大器电路、A/D转换器，最后驱动LED显示器显示测量结果。

Then the control system for boring the non-cylinder pin hole of piston was developed, whose main function modules including displacement ( detection,) temperature detection for thermal deformation compensation, constant current power and ( central) control unit.

然后研制了活塞异形销孔加工控制系统，包括主控、位移检测、热变形补偿温度检测和恒流源驱动等功能模块。

By using corrugated pipe bundle instead of the bare pipe bundle with the same stiffness as its tube sheet, the axial thermal compensation can be increased by 40.4 percent, and the corresponding pulling-out force is 53.2 percent of that of the bare pipe bundle.

在光管管束与壳体等刚度条件下，用波节管管束代替光管管束，轴向热补偿量可提高404%，相应的拉脱力为光管管束的532%。